A typical scene on the streets is to see drivers passing with their cars sideways on speed bumps like speed bumps Oklahoma City for example. But is that right? The practice can even prevent the underside of the vehicle from being damaged, but at the same time, it can end the car’s suspension. So, if you are in the habit of driving your car on its side over the speed bumps, it is good to rethink this practice before performing the maneuver again because when you pass the speed bump on the side, you end up forcing the car’s suspension excessively, which was made for walking in a straight line.
Whoever has a lowered car then makes this maneuver a common practice to avoid tangling the vehicle on the underside. But if, on the one hand, the practice prevents the underside of the vehicle from being affected, on the other hand, it causes serious damage to the structure.
According to experts, several parts end up being forced, such as the stabilizer bar, shock absorbers, and bearings. Those who drive sideways through the ditches also tend to detonate the car’s suspension similarly. The damping system of cars is made to pass through holes, speed bumps, and ditches; therefore, it is not necessary to go sideways, according to experts. That can hurt your pocket. To avoid problems, pay attention to the right way to perform the maneuver and avoid future inconvenience.
When approaching an obstacle, such as speed bumps and ditches, slow the car considerably and downshift. Keep the car completely straight and well-aligned. Go through the obstacle slowly, and start accelerating only after getting out of the bump or ditch. See how simple it is! Following these tips, you avoid future headaches; prevention is better than cure.
How To Pass The Speed Bump?
See below how to go through a speed bump without wearing out the vehicle’s mechanics.
Step 1
As soon as you see the speed bump, apply the brakes to reduce speed.
step 2
Downshift the gears one by one, without skipping any of them, until 2nd gear is engaged.
On higher speed bumps, shift with 1st gear very slowly to avoid impact or scraping the bottom of the car.
step 3
With your foot off the clutch and the steering aligned, go through the speed bump very slowly.
Forget that technique of crossing the speed bump with the car diagonally. This doesn’t reduce the impact; it just wears out the suspension system.
step 4
After passing the speed bump, resume acceleration to build up speed.
